Alex Mo писал(а):
Ставьте любую версии 4.5. Хотя, может и 5.0 подойдет.
На плате есть распайка под память в корпусе TSOP48. Можно ли впаять НАНД память в таком же корпусе?
Для работы с НАНД в прошивке должна быть ее поддержка, а если ее нету то и работать не будет.
Нарыл немного инфы по FORESEE NCEFAT28-08G:
FORESEE NCEFAT28-08G – NAND or eMMC? Discover here the true about this efSD memory
December 12, 2015 admin English News, Uncategorized 1
FORESEE NCEFAT28-08G
FORESEE NCEFAT28-08G
I have read some comments about Foresee NCEFAT28-08G memory. Some said it is a NAND Flash, others said it is an eMMC memory. None of them are true (or not at all).
I just got NCEFAT28-08G Datasheet and I could confirm that this is an hybrid memory called efSD memory with eMMC 4.51 specification compatibility.
FORESEE efSD is an embedded storage solution designed in the BGA package. The FORESEE efSD consists of NAND flash and eMMC controller. The controller could manage the interface protocols, wear-leveling, bad block management and ECC. FORESEE efSD has high performance at a competitive cost, high quality and low power consumption, and efSD is compatible with JEDEC standard eMMC 4.51 specifications.
FORESEE diagram
FORESEE diagram
Features:
eMMC4.51 specification compatibility (Backward compatible to eMMC4.41)
Bus mode:
Data bus width: 1 bit (default), 4 bits, 8 bits
Data transfer rate: up to 104MB/s (High Speed DDR)
MMC I/F Clock frequency : 0~52MHz
Operating voltage range:
Vcc(NAND) : 2.7 – 3.6V
Vccq(Controller) : 1.7 – 1.95V / 2.7 – 3.6V
Temperature:
Operation (-25 ℃ ~ +85℃)
Storage without operation (-40 ℃ ~ +85℃)
Others:
Compliance with the RoHS directive
Preventing from Sudden-Power-Off
Hardware ECC engine
Unique firmware backup mechanism
Global-wear-leveling
Supported features:
High Speed DDR, up to DDR mode at 52MHz
Partitioning, RPMB
Boot feature, boot partition
HW Reset/SW Reset
Discard, Trim, Erase, Sanitize
Background operations, HPI
Enhanced reliable write
Sleep / awake